It will make installation quicker. (Time is money)
An installer can power-stretch within 20 seconds of finishing a seam as opposed to waiting 20 minutes for the seam to cool.
Never again worry about someone stepping too close to your newly finished seam while cooling. The “Seamer Down Now” instantly cools the seam every 10 inches along the seam. It is like putting 20 “stay nails” in every 10 inches of the seam.
It makes the seams look better. As all installers know, some carpets tend to dimple up after seaming because the seaming process heats up the backing. The “Seamer Down Now” prevents this from happening due to the fact that it cools the carpet quickly thus not allowing the backing to over heat and dimple the carpet.
II. SOLUTION TO THE MOISTURE PROBLEM
The “Seamer Down Now” solves the moisture problem caused by the slow cooling of the seam. Never again have to run a metal tool box tray or board behind your seaming iron.
The “Seamer Down Now” Solves the “Blooming” of the fibers in plush carpeting caused by the excessive amount of heat taking so long to cool.
The “Seamer Down Now” Solves the problem of yellow streaks that appear when joining white carpet due to the moisture and fumes of the seaming tape. (The heat extraction is so fast that it prevents the fumes from dying the carpet)
III. USE OF LUAN BOARD OBSOLETE
The “Seamer Down Now” Solves the problem of carpet dimpling. Most installers are taught to put a 12” wide X 6 feet long luan board under the seam to keep the seam from being pushed down into the padding, thus avoiding dimpling of the carpet. The “Seamer Down Now” makes this unnecessary as it cools the seam quickly while pulling the seaming tape up to the back of the carpet with tremendous force; thus making the seam totally flat.
The “Seamer Down Now” solves the problem of uneven carpet. Even when using the luan board, seams on plush carpet will sometime dry unevenly as the carpet fibers on one edge of carpet may not be the same height as the other edge. However, the “Seamer Down Now” eliminates this problem as it’s tremendous suction and quick cooling power sets all fibers at a perfectly even height so the seam looks immaculate even on plush carpet.
IV. NEVER AGAIN HAVE TO “STAY NAIL”
The “Seamer Down Now” solves the problem of “Stay Nailing”; even on concrete where it is impossible to “stay nail”.
The “Seamer Down Now” solves the problem of skews and bows in pattern Berber. It dries the seam instantly allowing the installer to realign the pattern just as fast as you would normally move the seaming iron. Without the timely process of using “stay nails” as is currently taught to all installers.
The “Seamer Down Now” solves the problem of skews and bows in Plush carpet. This process is the same as if you were sewing the carpet together with needle and thread. The only difference is that you are doing it with the same speed as you would normally do so with your seaming iron. Absolutely no difference!!
The “Seamer Down Now” allows the installer to seam inward and outward bows on the same seam while instantly cooling the seam as you go.
The “Seamer Down Now” will soon make the old process of waiting for the seam to slowly cool obsolete.